Error codes for Kaiser washing machines

The error codes shown in the table do not apply to the Kaiser SMA, in which electronic controllers are installed from washing machines Indesit and Ariston.

 

Error code Error code interpretation Probable malfunction of the washing machine

 

E01

There is no signal to close the door from the limit switch of the lock.

The CM door is open;

The locking mechanism or the limit switch of the door lock is damaged

E02 The filling time of the CM tank with water is more than 2 minutes.

Low water pressure in the water supply;

Clogging the water inlet hose or solenoid valves

E03 The drain time of water from the CM tank is more than 1.5 minutes.

Clogged drain hose or filter

E04 The water level sensor generates a "tank overrun" signal.

The water fill solenoid valves are locked in the "OPEN" position;

During washing there was a significant increase in water pressure in the water pipe;

The beginning of the washing cycle was carried out with a closed inflow of water, and then water entered the tank already during the washing process;

Defective pressostat;

Defective electronic controller

E05 After 10 minutes from the beginning of the filling of the tank with water, the pressostat does not generate a "NOMINAL LEVEL" signal.

Low pressure or lack of water in the aqueduct;

The water inlet valve is faulty; - the pressure switch is faulty;

The electronic controller is defective; - faulty (locked in the "DISABLED" position) Aqua Spray valve (if installed)

E06 After 10 minutes from the beginning of operation of the drain pump, the pressure switch does not form the "EMPTY TANK" signal.

The drain pump is defective;

Defective pressostat;

Clogged drain hose or filter;

The reset valve is locked (in the "ON" position)

E07 The leakage of water into the SM tray is detected - open. Contacts of the float sensor AQUA STOP.

Float water leakage sensor AQUA STOP faulty;

There was a leakage of water into the SM tray due to depressurization of the tank, hoses or other elements of the CM

E08 The parameters of the mains have exceeded the recommended limits (190 ... 253 V, frequency 50/60 Hz)

 

Check the parameters of the supply network

E11 The door lock is not working.

Defective electronic controller

E21 There is no signal from the tacho generator about the rotation of the drive motor.

Faulty drive motor or tachogenerator;

The thermal motor switch is open;

There is no contact in the motor connector

E22 The drive motor rotates, despite the fact that there was no command to start it.

Defective electronic controller (triac drive motor);

Uneven distribution of laundry in the drum

E31 Temperature sensor short-circuited. The washing program is not interrupted, after it is completed, the error code is displayed

 Temperature sensor defective

E32 Open circuit in the temperature sensor circuit. The washing program is not interrupted, after it is completed, the error code is displayed

 There is no contact or an open in the temperature sensor circuit

E42 After the washing program has been executed, the manhole door is locked for more than 2 minutes

 Malfunction of the electronic controller;

The elements of the door lock are faulty